Tekton™ 10mm Ceramic Bearings with Patented High-Precision Built-In Spacer System
Next-level skate bearing tech – more speed, better handling, longer life!
ONLY FOR EXTRA-THICK 10MM AXLES. WILL NOT FIT STANDARD 8MM AXLES.
Currently out-of-stock. Stay tuned for updates on availability – estimated May 2024.
PATENTED Spacing System: Built-in half-spacers end in extra-wide contact surfaces (U.S. Pat. #9,126,101) that square up and self-stabilize inside wheels – correcting for flaws in bearing seat levelness, bearing seat spacing, axle diameter, and axle straightness. Locks in super-precise alignment, protects against friction and wear – better than any other system. Minimizes noise, too.
– Superior speed & acceleration
– More consistent wheel contact & grip while cornering
– More predictable slide release & hookup
– Longer wheel & bearing life
Premium Black Ceramic Balls: (genuine N4Si3 / trisilicon tetranitride) Lighter, smoother, harder, heat-resistant, rustproof. Reduce friction, increase acceleration and speed, scour / clean raceways! A whole new realm of fast.
Compared to even the finest steel bearing balls, ceramic balls have several remarkable advantages that justify their higher cost. They’re significantly lighter and lower in friction, so they accelerate faster and roll further at a higher speed, even with little or no lubricant. They’re so hard and strong that they crush dirt, debris, and even rust, which keeps the steel raceways clean and polished. They dissipate heat better, so bearings (and wheels) run cooler. They’re also rustproof, so they last longer even when ridden in wet conditions.
High-End Lubricant: Packed with premium “high-RPM” light grease from Kyodo Japan. Formulated for peak performance under actual skating stresses, not max free-spin time.
Inner Race: Specially contoured under seal to resist contamination. Extends 0.5mm outside to form built-in washer. No bearing spacers or axle washers required!
Additional Features: Dupont® engineering-grade Nylon retainers, removable rubber-coated steel seals with printed graphic. Meets or exceeds all criteria for ABEC-9 rating.
Eco-friendly packaging: No oversized metal tins or plastic boxes – just a minimal recyclable cardboard box.
No fake tech or exaggerations: Just more speed and longevity through real science and no-BS engineering!
100% free of:
• Random bearing tech adapted from other industries just for the sake of novelty.
• Expensive over-hyped raceway coatings that interfere with optimal polishing and may actually grind on balls.
• Over-hyped lubricant additives that accelerate wear not speed.
• Misleading claims that industry-standard features and factory processes are unique or special. (e.g., deep-groove raceways with micro-channels, fine-polishing, fiber-reinforced nylon retainers, hand-inspection, ultrasonic solvent washing, etc.)
Daniel Eng –
Haven’t had a chance to try these out on my Custom DIY Electric Skateboard but I timed a free wheel spin by hand at 4 min 30 seconds that’s quite impressive after installing right out of the box.. Can not wait to test these out when the weather gets better!